How to Make a Resin Joint in a Low-Voltage PVC Wire-Armoured Cable

What are the seven steps involved in making a resin joint (Scotch-cast joint) in a low-voltage PVC wire-armoured cable?

The steps involved in making a resin joint (Scotch-cast joint) in a low-voltage PVC wire-armoured cable are as follows:

Prepare the Cable Ends

Strip the outer sheath of the cable and remove the insulation to expose the conductors. Make sure to clean the exposed conductors thoroughly to remove any dirt, grease, or oxidation.

Choose the Appropriate Resin

Select the suitable resin for the joint based on the cable type, voltage rating, and environmental conditions. Follow the manufacturer's instructions for the correct resin selection.

Mix the Resin

Prepare the resin according to the manufacturer's instructions. Usually, this involves combining the resin components and stirring them thoroughly to achieve a homogeneous mixture.

Position the Cable Ends

Align the cable ends to be joined together, ensuring proper phasing and positioning. Make sure the conductors are properly aligned and not touching each other.

Apply the Resin

Pour the mixed resin into a resin container or mould. Carefully immerse the joint area and the exposed conductors in the resin, ensuring complete coverage.

Secure the Joint

Wrap the joint with appropriate insulating tape or use resin-filled heat shrink tubes to provide additional insulation and mechanical protection to the joint. Ensure a tight and secure fit. It's important to note that these steps provide a general overview of the resin joint process, and specific instructions may vary depending on the manufacturer's guidelines and the specific requirements of the cable jointing kit being used. Following the manufacturer's instructions and industry best practices is crucial to ensure a successful and reliable resin joint.
← The importance of proper refrigerant handling and equipment Yellow diamond traffic sign meaning →