Auto-MDIX: Making Network Connections Easier

What is the command to enable auto-MDIX on a device?

A. S1(config-if)# mdix auto
B. S1# auto-mdix
C. S1# mdix auto S1(config)# mdix auto
D. S1(config)# auto-mdix

Final answer:

Answer:

The correct command to enable auto-MDIX on a device is S1(config-if)# mdix auto.

Auto-MDIX stands for automatic medium-dependent interface crossover, which simplifies the process of connecting network devices by automatically detecting and configuring the appropriate cable connections. Enabling auto-MDIX on a device eliminates the need for crossover cables when connecting devices directly to each other.

The correct command to enable auto-MDIX is entered in the interface configuration mode. By using the command S1(config-if)# mdix auto, the interface will automatically detect whether a straight-through or crossover cable is being used and configure the pinouts accordingly.

This feature is particularly beneficial in scenarios where devices need to be connected directly without the use of a crossover cable. By enabling auto-MDIX, network administrators can simplify the network setup process and ensure that the correct connections are established without manual configuration.